Presetting The Power Meter; Preset Conditions - HP EPM-441A User Manual

Power Meter Operation

Presetting the Power Meter

Presetting the Power Meter
This section details the power meter's preset conditions.
The HP-IB address and command set, the data stored in the sensor
calibration tables and the zeroing and calibration data are not affected by
a preset. The calibration table selected is not affected.

Preset Conditions

The number of windows displayed is two.
dBm/W
Measurement units used is set to dBm.
Frequency
Cal Fac
• is set to 50 MHz.
Freq
• Cal Fac is set to 100%.
Meas
Setup
•
Display Format
analog in the lower window.
•
Anlg Mtr Scaling
( Min ).
•
Resolution 1 2 3 4
Rel
Offset
• Rel Off/On is set to "Off".
• is set to 0 dBm.
Rel
•
Offset Off/On
• is set to 0 dBm.
Offset
2-44
is set to digital in the upper window and
is set to 20.000 dBm (
is set to "3".
is set to "Off".
HP EPM-441A User's Guide
) and -70.000 dBm
Max