HP EPM-441A User Manual page 74

Power Meter Operation
Selecting a Digital or Analog Display
To select the format of the display in the currently selected window:
Meas
1. Press ,
Display Format
Setup
2. Press
Meter Dgtl Anlg
require. Pressing this key toggles between a digital and analog
display.
To select the range of the analog display in the currently selected window:
Meas
1. Press ,
Display Format Anlg Mtr Scaling
Setup
2. The current setting of the maximum and minimum values
displayed on the analog meter are displayed under the
softkeys respectively.
Min
3. To change either of these settings press the appropriate softkey.
The power meter displays the current value in a pop up window.
Modify this value (see below) until the desired value is displayed.
Use or
currently positioned.
Use or
4. To confirm your choice select the appropriate softkey. If the power
meter is in logarithmic mode press
linear mode select the appropriate softkeys from the following
menu:
More
Pressing Increment Multiplier
Decrement Multiplier
shown in front of
been selected confirms the entry.
2-34
.
to highlight the type of format you
,
to modify the digit on which the cursor is
to move to other digits.
. If the power meter is in
dB
%
Cancel
%
Increment
Multiplier
Decrement
Multiplier
Cancel
or
increases or decreases the multiplier
% . Pressing % after the correct multiplier has
.
and
Max
HP EPM-441A User's Guide