HP EPM-441A User Manual page 120

Menu Reference
Front Panel Menu Reference "System/Inputs" Menu
Clear Errors
Press this softkey to clear all the errors which are stored in
the power meter's memory.
Next
Press this softkey to move to the next error in the error queue.
The displayed error message is individually cleared each time
is selected.
Next
Done
Press this softkey to return to the "System/Inputs" menu.
•
Recorder Output
Press this softkey to access a menu which allows you to modify the
setup of the recorder output. Refer to "Recorder Output", on
page 2-39 for further information.
Output Off On
Press this softkey to switch the rear panel Recorder Output on
or off. The Recorder Output produces a dc voltage that
corresponds to the selected input channel power level in
Watts.
Max Power
Press this softkey to enter the input power level that you want
to represent the 1 V
Recorder Output.
Min Power
Press this softkey to enter the input power level that you want
to represent the 0 V
Recorder Output.
•
Service
Press this softkey to access a menu which allows you to test and
service your power meter.
Self Test
Press this softkey to access the power meter's self test menu.
Instrument Self Test
Press this softkey to run a series of tests on the power meter.
Refer to "Instrument Self Test", on page 2-48 for further
information on the tests run.
Confidence Check
Press this softkey to verify that the power meter makes an
accurate measurement of it's 1 mW POWER REF output.
3-20
maximum output voltage of the
dc
minimum output voltage of the
dc
HP EPM-441A User's Guide