Table of Contents
Advertisement
49-840in.fm Page 16 Thursday, August 19, 1999 10:47 AM
If the sensor has both warning and
alert triggers, use red wire tap-ins to
connect the warning trigger to the
harness's green wire and the alert
trigger to the harness's yellow wire.
CONNECTING
ACCESSORY DEVICES
Follow the instructions that come with
the accessory to mount and power it.
To have the alarm trigger the device
when you press
TRUNK
mote, use a relay (not supplied) to
connect the device's control input to
the main wiring harness's white wire
with yellow stripe.
To have the alarm trigger the device
when you press
FINDER
mote, use a relay (not supplied) to
connect the device's control input to
the main wiring harness's white wire
with red stripe.
Note: Auxiliary switched outputs con-
nect to ground when they are activat-
ed. If your auxiliary device requires
+12 volts for activation, or if you need
help using relays to make these con-
nections, call the Auto Alarm Helpline
at 1-800-598-2527 for assistance.
16
COMPLETING THE
INSTALLATION
Be sure you have the remote control
handy, then follow these steps to
complete the installation.
1. Reconnect your vehicle battery's
negative (–) battery cable.
Note: You must re-enter any pro-
grammed information into elec-
tronic devices in your vehicle,
such as clocks and radios, after
you connect the cable.
on the re-
2. Plug the main wiring harness into
the main module. Then immedi-
ately press
of the keychain remotes. The
alarm should chirp once, the
parking lights should flash and
the status indicator blinks. The
on the re-
alarm is now armed. Press
DISARM
tem.
If the alarm does not chirp,
immediately disconnect the har-
ness and the vehicle's negative
(–) battery cable. Recheck all
connections and check your vehi-
cle's and the alarm's fuses to be
sure none have blown. If you can-
not determine the problem, call 1-
800-598-2527
assistance.
Need Help? Call 1-800-598-2527
on one
ARM/DISARM
ARM/
again to disarm the sys-
for
additional
Advertisement
Table of Contents
