Omron SYSDRIVE 3G3FV-*-CUE Installation Manual page 33

Installation
Note 1. These are the cooling fan power supply and control circuit power supply input terminals.
Note 2. When 200 V is used, input 200 to 230 VAC from r – s200. When 400 V is used, input 380 to
460 VAC from r – s400.
Note 3. Do not apply DC power to the Inverters with a capacity of 55 to 160 kW. Otherwise, equipment
damage may occur.
D Control Circuit Terminals for All 3G3FV-j-CUE Models
Symbol
Se- 1 Forward run/Stop
quence 2
Reverse run/Stop
input
3 Multi-function contact input 1
4 Multi-function contact input 2
5 Multi-function contact input 3
6 Multi-function contact input 4
7 Multi-function contact input 5
8 Multi-function contact input 6
11 Sequence input common
35 Sequence switching terminal
36 Sequence power +24V
Analog 15 Frequency reference power supply
input (15 VDC)
33 Frequency reference power supply
(–15 VDC)
13 Frequency reference input (voltage)
14 Frequency reference input (current)
16 Multi-function analog input
17 Frequency reference input common
Shield E Shielded wire connecting ground
2-14
Name
Forward run at ON. Stops at OFF.
Reverse run at ON. Stops at OFF.
Set by parameter H1-01 (external fault a).
Set by parameter H1-02 (fault reset).
Set by parameter H1-03 (multi-step refer-
ence 1).
Set by parameter H1-04 (multi-step refer-
ence 2).
Set by parameter H1-05 (jog frequency ref-
erence)
Set by parameter H1-06 (external base-
block N.O.)
Common for 1 to 8.
NPN/PNP input switching terminal
Power common for 1 to 8
15-VDC power supply for frequency refer-
ence.
–15-VDC power supply for frequency refer-
ence.
Frequency reference voltage input terminal
Either 0 to +10 V or 0 to ±10 V can be se-
lected as the parameter (H3-01).
Current input terminal for frequency refer-
ence.
Set by parameter H3-05.
Common for analog input signal.
For connecting to shielded wires
www.dadehpardazan.ir 88594014-15
Function
Chapter 2
Signal level
Photocoupler
24 VDC, 8 mA
15 VDC, 20 mA
max.
–15 VDC, 20 mA
max.
0 to 10 VDC
(Input impedance:
20 kΩ)
0 to ±10 V
(Input impedance:
20 kΩ)
4 to 20 mA
(Input impedance:
250 kΩ)
0 to 10 VDC
(Input impedance:
20 kΩ)
0 to ±10 V
(Input impedance:
20 kΩ)
---
---