Emerson Rosemount 2090P Reference Manual page 105

Reference Manual
00809-0100-4690, Rev FC
June 2011
Appendix C
Analog Output Trim
Cloning
Commissioning
Configuration
Damping
Descriptor
Digital Trim
Failure Mode Alarm
Factory Characterization
Full Trim
HART (Highway
Addressable Remote
Transducer) Protocol
Lower Range Limit (LRL)
www.aotewell.com
Glossary
Some of the terms used in this manual relate specifically to the operation of
Rosemount transmitters, hand-held Field Communicators, and other
Rosemount products. The following list provides brief definitions. See the
sections listed for additional information.
Digital trim operation that allows adjustment of the output electronics to
conform to the plant standard of current. Two types of analog output trim are
available: 4–20 mA output trim and 4–20 mA other scale.
Off-line operation that uses a Field Communicator to copy configuration data
from one transmitter to one or more other transmitters that require the same
data.
Functions performed with the Field Communicator and the transmitter that
test the transmitter and test the loop, and verify transmitter configuration data.
Process of setting parameters that determine how the transmitter operates.
Output function that increases the response time of the transmitter to smooth
the output when there are rapid input variations.
Sixteen-character field for additional identification of the transmitter, its use, or
location. The descriptor is stored in the transmitter and can be changed using
the Field Communicator.
Format function that allows you to adjust the transmitter characterization for
purposes of digital calibration to plant standards. Digital trim includes two
separate operations: sensor trim and analog output trim.
Transmitter function that drives the analog output to a jumper-selectable high
or low value in the event of an electronics failure.
Factory process during which each sensor module is subjected to pressures
and temperatures covering the full operating range.
The sensor module memory stores data generated from this process
for use by the microprocessor in correcting the transmitter output during
operation.
Sensor trim function in which two accurate, end-point pressures are applied
and all output is linearized between them. The selected end points should
always be equal to or outside the LRV and URV.
Communications standard that provides simultaneous analog and digital
signal transmission between control rooms and field devices such as
transmitters.
Lowest value of the measured variable that the transmitter can be configured
to measure.
sales@aotewell.com
Rosemount 2088 and 2090
Industry Automation
C-1
+86-755-8660-6182