Samsung ProXpress C401 series User Manual page 119

Council Directive 2014/53/EU on radio equipment and telecommunications terminal equipment
and the mutual recognition of their conformity. A full declaration, defining the relevant Directives
and referenced standards can be obtained from your Samsung Electronics Co., Ltd.
representative.
European radio approval information (for products fitted with
EU-approved radio devices)
Low power, Radio LAN type devices (radio frequency (RF) wireless communication devices),
operating in the 2.4 GHz band, may be present (embedded) in your printer system which is
intended for home or office use. This section is only applicable if these devices are present. Refer
to the system label to verify the presence of wireless devices.
Wireless devices that may be in your system are only qualified for use in the
European Union or associated areas if a CE mark is on the system label.
The power output of the wireless device or devices that may be embedded in your printer is well
below the RF exposure limits as set by the European Commission through the Radio Equipment
Directive.
European states qualified under wireless approvals:
EU countries
European states with restrictions on use:
EU
EEA/EFTA countries
No limitations at this time
Regulatory compliance statements
Wireless guidance
Low power, Radio LAN devices (radio frequency (RF) wireless communication devices), operating
in the 2.4 GHz Band, may be present (embedded) in your printer system. The following section is
a general overview of considerations while operating a wireless device.
Additional limitations, cautions, and concerns for specific countries are listed in the specific
country sections (or country group sections). The wireless devices in your system are only
qualified for use in the countries identified by the Radio Approval Marks on the system rating
label. If the country you will be using the wireless device in, is not listed, contact your local Radio
Approval agency for requirements. Wireless devices are closely regulated and use may not be
allowed.
The power output of the wireless device or devices that may be embedded in your printer is well
below the RF exposure limits as known at this time. Because the wireless devices (which may be
embedded into your printer) emit less energy than is allowed in radio frequency safety standards
and recommendations, manufacturer believes these devices are safe for use. Regardless of the
power levels, care should be taken to minimize human contact during normal operation.
Regulatory information | 119