Garmin G5 Pilot's Manual page 56

AFCS
The following AFCS controls are located separately from the G5 and GMC 305/307
AFCS Control Unit:
CWS/AP DISC Button
(Autopilot Disconnect)
TO/GA Button
(Takeoff/Go Around)
MET Switch
(Manual Electric Trim)
44
G5 Electronic Flight Instrument Pilot's Guide for Non-Certified Aircraft
Table 3-2 Other AFCS Controls
An AP DISC/CWS Button is located on the pilot's control
stick. This button combines the functions of Autopilot
Disconnect and Control Wheel Steering. (Note: the Control
Wheel Steering function can be disabled in configuration
mode, which causes the button to perform the Autopilot
Disconnect function only)
Press and release the AP DISC/CWS Button to disengage
the autopilot.
Pressing and holding the AP DISC/CWS Button when
the autopilot is engaged will temporarily disengage the
pitch and roll servos and interrupt autotrim operation.
The pilot can then hand-fly the aircraft to a new attitude
and release the AP DISC/CWS button to re-engage the
autopilot servos and synchronize the flight director to the
aircraft's new attitude. The ability to use Control Wheel
Steering may be disabled in configuration mode if desired.
If the configuration supports it, pressing and holding the
AP DISC/CWS button while the autopilot is not engaged
will cause the autopilot to engage. If the flight director
was previously off, the default FD modes (PIT and ROL)
will be selected. The ability to engage the autopilot using
the CWS button may be disabled in configuration mode if
desired.
Selects flight director Takeoff or Go Around Mode (only
applies to a G5 installed as part of a G3X/G3X Touch
system).
Used to command manual electric trim for any properly
configured servo (pitch, roll, or yaw).
190-02072-00 Rev. G