Connecting The Handset; Connecting Ac Power - Radio Shack Two-Line Caller ID Phone With Speakerphone Owner's Manual

43-935.fm Page 11 Friday, January 14, 2000 3:07 PM
5. Press and lift out the handset hold-
er. Rotate it 180°, then snap it back
into place so it holds the handset.
CONNECTING THE
HANDSET
1. Plug one end of the supplied coiled
cord into the handset's modular
jack.
2. Plug the other end of the coiled cord
into the handset jack on the side of
the phone nearest the handset cra-
dle.
3. Place the handset on the cradle.
Note: Your local RadioShack store car-
ries several different lengths of coiled
phone cords that are especially useful
when wall mounting the phone.

CONNECTING AC POWER

You can power the phone using the sup-
plied 9V, 300-mA AC adapter and a size
®
K Adaptaplug adaptor (available at
your local RadioShack store).
Note: For the Caller ID function to work
and to use LINE 2, you must connect the
phone to AC power.
Cautions:
You must use a Class 2
!
power source that supplies
9V DC and delivers at least
300 mA. Its center tip must be set to
negative and its plug must fit the
phone's jack. The supplied
DC 9V
adapter meets these specifications.
Using an adapter that does not meet
these specifications could damage
the phone or the adapter.
• Always connect the AC adapter to
the phone before you connect it to
AC power. When you finish, discon-
nect the adapter from AC power be-
fore you disconnect it from the
phone.
Follow these steps to connect the AC
adapter.
1. Insert the supplied AC adapter's
barrel plug into the phone's
jack.
2. Route the AC
through the strain relief slot.
3. Plug the other end of the AC adapt-
er into a standard AC outlet.
DC 9V
adapter's cord
Strain Relief
Slot
11