Connecting And Charging The Handset Battery Pack - Radio Shack TAD-733 Owner's Manual

43-733.fm Page 9 Friday, September 17, 1999 8:57 AM
4. Snap the tabs at the wide end of the
bracket into place.
5. Plug the modular cord into the wall
plate jack. Align the base's keyhole
slots with the wall plate studs and
slide the base downward to secure
it.
6. Plug the AC adapter into a standard
AC outlet. The TAD-733 beeps and
appears.
00
7. Raise the base's antenna to a verti-
cal position.
CONNECTING AND
CHARGING THE
HANDSET BATTERY
PACK
The TAD-733 comes with a recharge-
able nickel-cadmium battery pack in the
handset but not connected. Before using
your phone, you must connect the bat-
tery pack and then charge it for about 15
hours.
1. Press down and slide off the battery
compartment cover.
2. Lift the battery pack out of the com-
partment, and plug its connector into
the socket inside the compartment.
The connector fits only one way.
3. Put the battery pack in the compart-
ment and replace the cover.
9