Setting The Day And Time - Radio Shack TAD-727 Owner's Manual

43-727.fm Page 22 Monday, December 20, 1999 4:28 PM
2. Repeatedly press
on the base until the TAD
SKIP
announces and displays the number
of rings you desire – "two" so the
TAD answers on the second ring,
"five" for fifth ring, or "toll saver"
when you want to use the toll-saver
function.
3. Press
ANSWER
. The TAD sounds a long beep
and announces the selected num-
ber of rings.
Note: Press each button within 30 sec-
onds. If you take longer, the setting pro-
cedure is canceled automatically.
SETTING THE DAY
AND TIME
You must set the day and time so the
TAD can record the correct day and time
of each message.
1. Hold down on the base until a
STOP
long beep sounds.
announces the day of the week.
flashes on the digital display.
22
or
PREVIOUS
PREVIOUS
PLAY/
REPEAT
SKIP
or
PLAY/REPEAT/
The TAD
CL
2. Press or
PREVIOUS
TAD announces the correct day of
the week.
3. Press
PLAY/REPEAT/
announces the hour and "AM" or
"PM."
4. Press or
PREVIOUS
TAD announces the correct hour,
including AM or PM.
5. Press
PLAY/REPEAT/
announces the minute.
6. Press or
PREVIOUS
TAD announces the correct minute.
Holding down
PREVIOUS
advances the minute rapidly and
announces minutes in 10 minute
increments. Release
and the TAD announces the
SKIP
minute setting. If you advance too
far when holding down
, press the opposite button.
SKIP
7. Press
PLAY/REPEAT/
announces the minute and sounds a
beep. Then the seconds start to
count from 0.
STOP
until the
SKIP
.The TAD
until the
SKIP
.The TAD
until the
SKIP
or
SKIP
or
PREVIOUS
or
PREVIOUS
. The TAD