Table of Contents
Advertisement
43-727.fm Page 21 Monday, December 20, 1999 4:28 PM
TAD OPERATION
You can use the base or the handset to
control the TAD. With the handset, you
set the remote operation personal identi-
fication number (PIN), select the outgo-
ing
message,
record
messages, memos, or telephone con-
versation, turn the TAD on and off, play
messages, and delete a current mes-
sage. At the base, you can set the day
and time, set the number of rings before
the TAD answers an incoming call, se-
lect the outgoing message, set incoming
message recording time, record outgo-
ing messages, memos, or telephone
conversation, turn the TAD on and off,
play and delete messages, and adjust
the TAD's volume.
Note: While you are using the base to
control the TAD, you can still answer in-
coming calls with the handset or another
phone on the same telephone line.
USING THE HANDSET TO
CONTROL THE TAD
To control the TAD with the handset,
press
in standby mode. The
REMOTE
TALK/LOW BATT indicator on the hand-
set lights, and two bars flash on the digi-
tal display on the base.
The TAD announces the number of
messages you have (if any). If the TAD
has no messages, the TAD announces
"You have no messages." Then the TAD
outgoing
is ready to accept a command.
Note: If you need help during operation,
press
STOP/HELP/
plays a series of voice prompts to guide
you through the handset operation.
When you finish operating the TAD, wait
until the TALK/LOW BATT indicator
turns off or press
SETTING THE NUMBER
OF RINGS
Follow these steps to set how long the
TAD waits before it answers a call (2
rings, 5 rings, or toll-saver).
Note: If you plan to check your messag-
es by long distance, set the number of
rings to toll-saver (see "Using the Toll-
Saver" on Page 28).
1. Hold down
until the TAD announces the num-
ber of rings ("two", "five" or "toll-
saver") and the display flashes the
current setting
. The TAD
TONE
again.
REMOTE
on the base
ANSWER
2
,
5
, or
SA
.
21
Advertisement
Table of Contents
