Using Flash; Using Tone Services On A Pulse Line; Using The Intercom - Radio Shack TAD-727 Owner's Manual

43-727.fm Page 17 Monday, December 20, 1999 4:28 PM

USING FLASH

Flash performs the electronic equiva-
lent of a switchhook operation for spe-
cial services, such as Call Waiting.
For example, if you have Call Waiting,
press to answer an incoming call
FLASH
without disconnecting the current call.
Press again to return to the first
FLASH
call.
Note: If you do not have any special
phone services, pressing
disconnect the current call.
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse dialing, you can still use
these special tone services by following
these steps.
1. Be sure
PULSE/TONE
.
PULSE
2. Dial the service's main number.
3. When the service answers, press
you dial are sent as tone signals.
4. After you complete the call, return
the handset to the base or press
TALK
resets to the pulse mode.

USING THE INTERCOM

You can use the TAD-727 as a two-way
pager and intercom between the base
might
FLASH
and handset. This is useful if the hand-
set is away from the base and you want
to locate it, or if you want to have a con-
versation between someone with the
handset and someone at the base.
Note: If a call comes in during an inter-
com conversation, the person using the
handset can answer the call by pressing
TALK
nected.
is set to
. Any additional numbers
TONE
. The phone automatically
, but the intercom call is discon-
17