Setting The Dialing Mode; Setting The Handset's Volume; Setting The Ringer Tone - Radio Shack ET-547 Owner's Manual

25-channel cordless telephone with 3 priority and 10 speed-dial memories
Table of Contents

Advertisement

43-1047.fm Page 11 Tuesday, August 17, 1999 11:37 AM
• The supplied battery should last
for about a year. When the battery
loses its ability to fully recharge,
order a replacement battery from
your local Radio Shack store (see
"Replacing the Battery").
SETTING THE DIALING
MODE
Set
on the back of the
TONE/PULSE
base for the type of service you have.
If you are not sure which type you
have, do this test.
1. Set
TONE/PULSE
2. Lift the handset and listen for a
dial tone.
3. Press any number other than
Note:
If
your
requires that you dial an access
code (
, for example) before you
9
dial an outside number, do not
press the access code.
If the dial tone stops, you have
touch-tone service. Leave
set to
PULSE
TONE
to
.
TONE
.
0
phone
system
TONE/
.
If the dial tone continues, you
have pulse service. Set
to
.
PULSE
PULSE
SETTING THE
HANDSET'S VOLUME
To adjust the handset's ringer volume,
press
while the phone is not in
R.VOL.
use. To adjust the volume of your tele-
phone conversation, press
while the call is in progress.
SETTING THE RINGER
TONE
You can select one of the two different
ringer tones when the phone is not in
use. Press
R.TONE
to switch between
a "chirping" and a "warbling" ringer
tone.
TONE/
R.VOL.
11

Advertisement

Table of Contents
loading

Table of Contents