Table of Contents
Advertisement
43-1032.fm Page 8 Tuesday, August 17, 1999 9:41 AM
• If the CHARGE/TALK indicator
does not light when you place the
handset on the cradle, be sure the
battery is connected to the pins
inside the battery compartment
and the AC adapter is securely
connected to the base. Also,
check the charging contacts on
the handset and base. If the con-
tacts are dirty or tarnished, gently
clean them with a pencil eraser.
• About once a month, fully dis-
charge the battery by keeping the
handset
off
the
flashes, then
handset to the cradle and fully
recharge the battery. If you do not
fully discharge and recharge the
battery periodically, it loses its
ability to fully recharge.
• The first time you use your phone
after installing a new battery, the
handset might not work and might
sound an error tone when you
press
. This might also occur
TALK
when you recharge a battery that
has been completely discharged.
If this happens, be sure the hand-
set is turned on, then return the
handset to the cradle for 5 sec-
onds. This resets the security
access code.
8
SETTING THE DIALING
MODE
Set
base for the type of service you have.
If you are not sure which type you
have, do this test.
1. Set
2. Lift the handset and listen for a
cradle
until
3. Press any number other than
return
the
4. If the dial tone stops, you have
If the dial tone continues, you have
pulse service. Set
PULSE
on the back of the
TONE/PULSE
to
TONE/PULSE
TONE
dial tone.
touch-tone service.
TONE/PULSE
.
.
0
.
to
Advertisement
Table of Contents
