Storing Your Area Code - Radio Shack ET-2101 Owner's Manual

43-2101.fm Page 15 Wednesday, February 23, 2000 9:12 AM
2. Press so the STATUS/MESSAGE indicator lights and
TALK
listen for a dial tone.
3. Press any number other than
Note: If your phone system requires that you dial an
access code ( , for example) before you dial an outside
9
number, do not press the access code either.
If the dial tone stops, you have touch-tone service. If the
dial tone continues, you have pulse service.
4. Place the keypad on the base or press
5. If you have tone service, leave
you have pulse service, set
Note: Replace the keypad on the base for 5 seconds after you
set the service type.

STORING YOUR AREA CODE

To dial a number from a Caller ID record (see "Dialing Numbers
from a Caller ID Record" on Page 29), you must first store your
local area code in the phone's memory. When you dial from a
Caller ID record, the system skips the area code if it matches
the one you stored. Follow these steps to store your area code.
1. Make sure is not pressed.
TALK
2. Hold down
CHANNEL
appears.
or .
0 1
.
TALK
set to
TONE/PULSE
to
TONE-PULSE PULSE
for 2 seconds. AREA CODE =???
Preparation
. If
TONE
.
15