Turning Auto Talk On/Off; Turning Caller Id/Call Waiting On/Off; Storing Your Area Code - Radio Shack 43-3514 Owner's Manual

TURNING AUTO TALK
ON/OFF
Your phone is preset so you must press
when you lift the handset from the base
TALK
to answer a call. With Auto Talk turned on,
you can answer a call by just lifting the hand-
set from the base. If the handset is away
from the base, you can answer by pressing
any key.
Follow these steps to turn Auto Talk on or
off.
1. Lift the handset and press
$XWR 7DON $XWR
$XWR $XWR
menu appears with
2. Press to change the auto talk
SELECT
2Q 2Q 2Q 2Q 2II 2II 2II 2II
setting. or appears indicating the
selected setting.
3. Return the handset to the base or press
to store the new setting.
MENU
TURNING CALLER ID/CALL
WAITING ON/OFF
If you subscribe to Call Waiting with Caller ID
service, you can set the phone to show Call-
er ID information for an incoming call even
while you are using the phone.
Follow these steps to turn Caller ID/Call
Waiting on or off.
1. Lift the handset and press
2. Press or
2 VOL/CID
(Caller ID/Call Waiting).
3. Press SELECT to change the Caller ID/
Call Waiting setting.
appears indicating the selected setting.
4. Press then return the handset to
MENU
the base to store the new setting.
With the Opt setting, you can use the ad-
vanced Caller ID/Call Waiting options. See
"Call Waiting Options Service" on Page 17.
STORING YOUR AREA
CODE
You can store your local area code in the
phone's Caller ID record so it does not show
the area code if the received call is from your
local area. If for some reason you need to
dial the area code (or store in the memory),
you can add it afterwards. See "Adding/De-
leting the Area Code" on Page 19.
. A
MENU
7DON
7DON 7DON
selected.
Note: If your calling area requires 10-digit di-
aling including area code, do not enter the
area code.
Follow these steps to store your area code.
.
MENU
9 9 9 9
&,'&: &,'&: &,'&: &,'&:
to select
2Q 2Q 2Q 2Q 2II 2II 2SW 2SW
2II 2II 2SW 2SW
, , or
Preparation
1. Lift the handset and press
9 9 9 9
2. Press or
3 VOL/CID
$UHD &RGH $UHD $UHD $UHD &RGH &RGH &RGH
.
3. Press , then enter your three-
SELECT
digit area code. If you make a mistake,
repeatedly press
REDIAL/
7 7 7 7
to move the cursor over the incorrect
digit, then enter the correct number.
Note: If an area code is already stored,
it appears on the display. To delete the
area code, press
times. Then enter your area code. Or
6 6 6 6
you can use
REDIAL/
move the cursor and edit the area code.
4. Press to store the area code,
SELECT
then press or return the handset
MENU
to the base to clear the display.
.
MENU
twice to select
6 6 6 6
or
FLASH/
three
DELETE/CH
7 7 7 7
or to
FLASH/
11