Mounting The Base Ona Wall Plate - Radio Shack ET-1105 Owner's Manual

MOUNTING THE BASE ON
A WALL PLATE
1. Follow Steps 1 through 3 under
"Placing the Base on a Desk Top" on
Page 6.
2. Route the modular cord through the
left groove on the bottom of the base
and the adapter cord through the
groove below the strain relief slot.
3. Insert the tabs on the narrow end of
the bracket into the slots on the bot-
tom of the base as shown and route
the other end of the short modular
cord through the center of the brack-
et.
8
4. Push the tabs on the wide end of the
bracket into the lower slots on the
bottom of the base.
5. Plug the short modular cord's other
end into the wall plate jack, align the
base's keyhole slots with the wall
plate studs, and slide the base
downward to secure it.