Table of Contents
Advertisement
SETTING THE AREA
CODE
When you return a call from a Caller ID
record (see "Dialing Numbers from a
Caller ID Record" on Page 21), your
phone automatically dials 1, the area
code, and the number. The ET-1105 lets
you store one local area code and three
neighborhood area codes. If the number
you call has the same area code with
your local area code, the ET-1105 dials
the 7-digit local number. If the number
you call has the same area code with one
of three neighborhood area codes, the
ET-1105 dials the 10-digit local number.
Follow these steps to set area codes.
Note: If you make a mistake or do not
press a key within 10 seconds during
these steps, start again at Step 1.
1. Pres
. The language selection
SETUP
display appears.
2. Press
/ . The currently entered
area codes (or
000/000/000
/
3. Enter your local area code first, then
the three neighborhood area codes,
then press
SETUP
12
AREACODE=000
) appear.
to store them.
SETTING THE RINGER
Turning the Ringer On or Off
You can turn the ET-1105's ringer on
and off. Set
RINGER
handset to
to hear an incoming call or
ON
a page from the base. Set
to silence the ringer.
OFF
Note: With the ringer off, you can still
make or receive calls using this cordless
phone. Telephones on the same line still
ring when there is an incoming call, and
the IN USE indicator on the ET-1105's
base flashes until you answer the call.
Checking/Setting the Ringer
You can set the ET-1105's handset to
sound any of three ringer types. The
handset is preset to use the ringer tone
(
). To change or hear the different
1
tones, press
FLASH
not in use.
PROG. RINGER
With
set to
RINGER
then press
FLASH
(The last number button you pressed is
the tone you will hear.)
on the side of the
RINGER
RINGER
when the phone is
displays.
, press
,
, or
ON
1
2
to confirm the setting.
to
,
3
Advertisement
Table of Contents
