On A Wall Plate - Radio Shack ET-1102 Owner's Manual

43-1102.fm Page 7 Tuesday, August 17, 1999 4:37 PM
4. Insert the supplied AC adapter's
barrel plug into the
the back of the base.
5. Route the adapter's cord through
the strain relief slot on the bracket.
6. Plug the adapter into a standard AC
outlet.
7. Lift the base's antenna to a vertical
position.

On a Wall Plate

1. Insert the bracket's tabs into the
base's lower tab slots as shown,
then press down on the bracket's
clips and insert them into the clip
slots.
jack on
DC IN 9V
2. Plug one end of the supplied short
Strain
Relief Slot
3. Insert the supplied AC adapter's
4. Route the adapter's cord through
Lower
Tab
Slots
Tabs
Clip Slots
modular cord into the
on the back of the base.
barrel plug into the
DC IN 9V
the back of the base.
the narrow groove on the bottom of
the bracket.
jack
TEL LINE
jack on
Narrow
Groove
7