Encoder Streams - Bosch MIC IP starlight 7000i User Manual

MIC IP starlight 7000i
The basic setting Auto automatically adjusts the quality to the settings for the P-frame video
quality.
I/P-frame delta QP
This parameter sets the ratio of the I-frame quantization (QP) to the P-frame quantization
(QP). For example, you can set a lower value for I-frames by moving the slide control to a
negative value. Thus, the quality of the I-frames relative to the P-frames is improved. The total
data load will increase, but only by the portion of I-frames. The basic setting Auto
automatically adjusts to the optimum combination of movement and image definition (focus).
To obtain the highest quality at the lowest bandwidth, even in the case of increased
movement in the picture, configure the quality settings as follows:
1.
2.
3.
Background delta QP
Select the appropriate encoding quality level for a background region defined in Encoder
Regions. The lower the QP value, the higher the encoding quality.
Object delta QP
Select the appropriate encoding quality level for an object region defined in Encoder Regions.
The lower the QP value, the higher the encoding quality.
Default
Click Default to return the profile to the factory default values.
6.3

Encoder Streams

Note: If you access this menu while the camera is recording, the following message appears at
the top of the page:
Recording is currently active. Therefore, for 'Current profile' the respective stream profile
selected for recording is displayed for information.
Property
Select one of the resolutions for each stream.
Note: In order to select the option "720p50/60" here, you must first set the field Base frame
rate in Camera > Installer Menu to "60 fps."
The table below identifies the options available in the field Property for Stream 1 and the
available options in the field Property for Stream 2, depending on the options selected for
Stream 1.
Stream 1
(recording)
Bosch Security Systems
Observe the coverage area during normal movement in the preview images.
Set the value for Min. P-frame QP to the highest value at which the image quality still
meets your needs.
Set the value for I/P-frame delta QP to the lowest possible value. This is how to save
bandwidth and memory in normal scenes. The image quality is retained even in the case
of increased movement since the bandwidth is then filled up to the value that is entered
under Maximum bit rate.
720p
1080p
Options
User Manual
Camera | en 29
2017.11 | 1.2 |