Advertisement
2. Put on your headset and press the Multifunction Button on the base. An audible
tone will shortly be heard.
3. Lift the telephone's handset from the cradle and listen for a dial tone in your headset.
4. Using your desk telephone, make a call to someone who will act as your test person.
5. While speaking with your test person, adjust the blue microphone volume adjust-
ment button until he/she hears your voice at an appropriate level.
2.2 Setting up for mobile telephone use
The GN 6110 headset is also compatible with Bluetooth mobile phones. The mobile
phone you use with your GN 6110 must be Bluetooth technology-equipped.
Setting up the headset to a mobile phone (pairing)
Before using your headset for the fi rst time with a mobile
phone, you must pair your headset and mobile telephone
by completing the following:
1. Press and hold down the Multifunction Button on the
headset for 5 seconds, after which the headset indica-
tor will light. [A]
2. Within 3 seconds, open the headset boom arm. The
headset can be paired within the next 5 minutes.
3. Put the mobile phone into pairing mode, according to
your mobile phone's user manual. [B]
Note: Your mobile phone must be Bluetooth-equip-
ped in order to pair it with the GN 6110.
4. From your mobile phone, perform a device discovery
so that your mobile phone will fi nd your headset and
pair to it. This may take several seconds.
™
Bluetooth
is a trademark owned by Bluetooth SIG, Inc. USA and licensed to GN Netcom.
8
GN6110_contents_EU_21-10-03.indd 8-9
A
B
Note: Ensure that the mobile device and
the headset are within 1 metre of each
other. [C]
5. When your mobile phone prompts you, enter the following
4-digit passkey code: 0000.
The mobile phone will now begin pairing and store your GN 6110 headset in its
memory. Your mobile phone screen will advise that pairing has been successful.
The headset indicator will rapidly fl ash 10 times, and a beep will be heard in the
headset to indicate successful pairing.
After successful pairing, your headset is ready to use with your mobile phone. Consult
your mobile phone's user guide for full details on utilising a Bluetooth headset with
your mobile phone.
3.0 Operating the GN 6110
3.1 Operation – with desk telephone
If your headset is in its base, press the release headset button to free the headset before
using it.
Turning headset ON:
Open the headset boom arm. The headset indicator will light for 2 seconds, and then
continue to fl ash slowly as long as the headset is on.
Turning headset OFF:
Close the headset boom arm. The headset indicator will light for 2 seconds, after which
it will turn off.
C
max
1m
9
23-10-2003, 09:39:22
Advertisement
