Advertisement
Note: For your convenience, you may also feed the telephone cord through the
base's right or left slot, depending if your desk telephone is positioned to the right
or left of the base.
5. Use the cord management strips to fasten and organise the cords. [E]
Charging headset
Before using your headset, charge it for a minimum of
two hours. You may charge the headset by placing it in
the base or with the travel charger cord.
During initial (and subsequent) charging, you may con-
tinue to use your desk telephone as normal.
See Section 4.5 for full details on charging batteries and
the battery charge level indication.
Pairing of headset to the desk telephone and verifying
pairing
The headset and the base in their original product box have been factory-paired to
ensure proper functioning of your GN 6110. You do not need to pair these two devices,
and you may now proceed to the Clear dial tone adjustment section.
If original pairing is lost (by resetting the base, changing your headset or changing your
base), you will have to pair your headset to the base again. You may also verify pairing
between the headset and base at any point (except during telephone conversations).
See Section 4.6 for these instructions.
6
GN6110_contents_EU_21-10-03.indd 6-7
Clear dial tone adjustment
Desk telephones operate on a range of standards. In order for your GN 6110 to work
with your desk telephone and to hear a clear, crisp dial tone, you must set the correct
dial tone setting. Consult the inside back cover of this user guide for the most common
telephone models and settings.
Complete the following instructions to set the correct dial tone adjustment:
1. Open the compartment cover on the bottom of the base and
locate the termination switch [A].
2. Put on your headset and press the base's Multifunction but-
ton. An audible tone will shortly be heard.
3. Lift the telephone's handset from the cradle and listen for a dial tone in your headset.
4. If there is no dial tone or it is not clear, stepwise slide the termination switch
through all 7 settings (along the A-G range), listening for the clearest possible dial
tone. If the dial tone is just as clear in position A as in position G, leave the switch in
position A.
5. When you hear the clearest dial tone, you have located the correct termination set-
ting.
Microphone volume adjustment
In order to ensure that your voice is neither too loud nor too soft when calling others,
adjust the transmit sound volume. You will need to make a call with your desk tele-
phone to adjust it.
Complete the following instructions to adjust the transmit volume:
1. Open the compartment cover on the bottom of the base and
locate the blue microphone volume adjustment button [A].
A
A
7
23-10-2003, 09:39:21
Advertisement
