Advertisement
To use your headset, press the release headset button to free the head-
set from its base.
During initial (and subsequent) charging, you may use your desk tele-
phone's handset.
Battery charge indication
The headset indicator will light to indicate charging, and will turn off when fully
charged. The 4 lights of the battery indicator show the approximate battery charge
level of the headset:
•
1 lit indicator represents 25% of a full charge
•
4 lit indicators represent a full charge.
Charging with the travel charger
The travel charger works universally (90-240 V), letting you charge the headset in any
country. You will need to purchase separately any required electrical outlet plug-in
adapters.
To charge with the travel charger, insert the travel charger cord's electrical plug into the
electrical outlet and the cord's mains plug into headset.
Note: To ensure optimal charging, ensure that the mains plug of the travel charger is placed
correctly into the headset. The headset indicator will light when the headset is charging.
Battery saving mode
To save power, the headset enters snooze mode after 1 minute of inactivity. This will
in no way affect the normal use of the headset, and it will re-activate itself immediately
when used or when a call is received.
20
GN6110_contents_EU_21-10-03.indd 20-21
4.6 Pairing your headset to the desk telephone
Pairing your headset
In order for your GN 6110 to work correctly, the headset and the base must be paired
together. For your convenience, these two devices in their original product box have
been factory-paired.
If this original pairing is lost (by resetting the base, changing your headset or changing
your base), you will have to pair your headset again to the base. Complete the following
steps to pair your headset again to the base:
1. Press and hold down the Multifunc-
tion Button on the headset for 5
seconds [A], after which the headset
indicator will light [B].
2. Within 3 seconds, open the headset
boom arm. The headset can now be
paired within the next 5 minutes [B].
3. Press and hold down the Multifunc-
tion Button on the base for 5 seconds,
after which the pairing indicator will
light. [C]
Note: Ensure that the headset and
base are within 1 metre of each other. After 5 seconds, the base will automatically
pair with the headset.
Successful pairing will be indicated by 10 rapid fl ashes of both the headset indicator
and the pairing indicator. A beep will also be heard in the headset.
A
B
~ 5 sec
~ 5 sec
C
23-10-2003, 09:39:26
21
Advertisement
