Advertisement
How long do I have to charge the headset before I can use it?
It takes 2 hours to fully charge your headset. Although you may already use your head-
set after 20 minutes of charging, we recommend you allow 2 hours of charging before
you use your headset.
The battery indicator represents the charge level of your headset. One lit indicator light
represents a 25% charge and when all four indicator lights are lit the headset is fully
charged.
How do I lift the headset out of its base?
Press the headset release button fi rst, and then lift the headset from the base unit. The
headset release mechanism allows the headset to sit fi rmly in the base, thus guarantee-
ing its charging.
Can I wear the headset on either the left of the right ear?
Yes, you can wear the headset on either the left or the right ear. To change the wear-
ing ear, open the headset boom arm, open and remove the earhook, turn the headset
over and fi nally reinsert the earhook. Full instructions and illustrations can be found in
Section 4.3.
What is the clear dial tone adjustment for?
Desk telephones operate on a wide range of standards and use different kinds of inter-
nal components. The GN 6110 works with a very wide range of desk telephones, but it
still must be set to match your desk telephone's standard. The GN 6110's termination
switch (located at the bottom of the base) has a sliding 7-setting range that must be
adjusted until you hear a clear, crisp dial tone. Once you have a clear dial tone, your GN
6110 is correctly adjusted.
26
GN6110_contents_EU_21-10-03.indd 26-27
Why do I need to volume match the headset and desk telephone?
Volume match ensures consistency between the volume levels of received calls. Once
you have completed volume match, the volume you hear in your ear will be at the same
level, irrespective of if the call comes from your desk or mobile phone. Furthermore,
if you adjust the headset's volume up or down during normal use, it will apply consis-
tently for calls from both your desk and mobile phone.
How do I make and end calls with my headset?
To make a call, open the boom arm, press the Multifunction Button, lift the telephone's
handset (or simply press its line button), listen for the dial tone and dial the desired
number.
To end a call, press the Multifunction Button on the headset or base and lower the
telephone's handset (or simply press its line button).
6. Cleaning, safety and maintenance
Clean the headset, including the headset boom arm and ear hook piece, by wiping
with a slightly damp cloth as required. Dampen the cloth with only water and a little
washing-up liquid if needed. Avoid getting moisture into any button sockets or other
openings. The base and cords may be dry-dusted as required.
Do not immerse the GN 6110 in water.
The plastic bags the GN 6110 and its parts are wrapped in are not toys for children. The
bags themselves or the many small parts they contain may cause choking if ingested.
27
23-10-2003, 09:39:27
Advertisement
