View Port Incoming Data; Nmea2000 Port - Si-tex Explorer Nav Pro User Manual

5. Press [ENTER] to open the "Output options" page
6. Press [ENTER] on the "Enable output" button
On the "Output options" page you can select:
● the NMEA talker ID to use as a prefix for NMEA 0183 sentences
● the NMEA 0183 version (2.0, 3.0 or 4.1)
● the NMEA 0183 sentences for output

16. 3 View port incoming data

View port incoming data function allows the chart plotter to act as a computer terminal and
display the incoming data exactly as it is received. This option is available in the "NMEA 0183
device" mode.
If the data displayed on the screen is unrecognizable, you may have selected the wrong
input parameters for your particular accessory. Check your accessory manual to be sure that
you have selected the proper interface format. If the screen is blank, the connection may be
interrupted, and no data is being received. Use "Resume/Pause" button at the top bar of the
page to pause (or continue after pause) data displaying.

16.4 NMEA2000 port

CAN bus is a communication protocol that shares multiple data and signals through a single
backbone cable. You can simply connect any CAN bus devices onto the backbone cable
to expand your network onboard. With CAN bus, IDs are assigned to all the devices in the
network, and the status of each sensor in the network can be detected. All CAN bus devices
can be incorporated into the NMEA2000 network.
This port can be turned on/off on the CAN port settings page:
1. Press [ENTER] on the "CAN port NMEA 2000" tab
2. Select "None" to turn the port off or "NMEA 2000" to turn it on
3. Press [ENTER]
The port output function is available in the "NMEA 2000" mode.
1. Open the "Output options" page
2. Press [ENTER] on the "Enable output" button
3. Select the desired NMEA 2000 PGNs in the list below for output
Chart Plotter - User Manual
57