Gigaset C530 IP Manual page 119

Gigaset C530 IP / LUG - USA en / A31008-XXXXX-XXXX-X-XX / web-conf.fm / 25.03.2015
Configuring the phone via the Web configurator
Saving and restoring system settings
Once you have configured your base and after each configuration change, you can save the
current base settings in a file on the PC (suffix .cfg).
If you change the settings accidentally or you need to reset the base due to a fault (base reset),
you can reload the saved settings from the file on your PC to your phone.
The contents of the .cfg file include:
u
The settings for the local network (IP configuration)
u
The data for the (VoIP) connections established
u
The assignment of send and receive connections
u
Your own local area code and access code
u
The network mailbox number
u
The Internet services settings
u
The ECO DECT settings
You can save and restore the system settings via the web page:
¤
Settings
Updating firmware for the base/restoring firmware updates, activating/
deactivating automatic updates
You can start firmware updates and downgrades via the web page:
¤
Settings
Regular updates to the base firmware and the provider profile for your VoIP connections
(general provider data) are made available on an Internet configuration server. You can
download these updates onto your base as required. The URL for this server is stored in the base.
You have the following options:
u
Starting a firmware update
If a new version of the firmware is available, this is downloaded to the base and the base is
restarted. A firmware update lasts approx. six minutes. The duration also depends on the
bandwidth of your DSL connection.
u
Enabling/disabling the automatic version check
When the version check is enabled, the phone checks on a daily basis whether the Gigaset
configuration server has a new version of the phone firmware.
If the telephone is not connected to the Internet at the time when the check is to be
performed (e.g. because the router is disabled), the check is performed as soon as the phone
is reconnected to the Internet.
If a new version is available, a message to this effect is shown on the display of the registered
handsets. You can start the update of the firmware on one of the handsets.
u
Downgrading firmware
You have the following options:
- You can reload the firmware version that was loaded before the last update on the base.
- You can reload the firmware version that was loaded by default onto the phone.
The selected firmware is reloaded onto the phone and the current firmware is overwritten.
118
¤
Management Save & Restore
¤
Management Firmware Update