Table of Contents
Advertisement
Basic Operations
Making a Telephone Call
1. From a Handset:
a. Press the TALK or Speaker, and then enter phone number
b. Or, you can enter phone number first then press the TALK
or Speaker key. When using this method, you can use the
CLEAR (Left) and DELETE (Right) soft keys to edit the
number entered. "Delete" erases the last digit entered.
"Clear" erases the entire line but remains in the dialing
mode
c. To abort dialing at any time, press the END key
2. From the Base Unit:
a. Press the Dial, or Speaker, or Headset button, or pick up
the Handheld, and then enter the phone number
b. Or, you can enter phone number first then press the Dial,
or Speaker, or Headset button, or pick up the Handheld
(off-hook). When using this method, you can use the
CLEAR (Left) and DELETE (Right) soft keys to edit the
number entered. "Delete" erases the last digit entered.
"Clear" erases the entire line but remains in the dialing
mode
c. To abort dialing at any time,
i)
Press the Speaker button if dialing by pressing Dial or
Speaker button
ii) Press the Headset button if dialing by pressing the
Headset button
iii) Return the Handheld to cradle (on-hook) if dialing by
picking up the Handheld
Notes:
a. If all lines are busy or designated for other handsets, the
LCD shows " No line available" and then returns to standby
b. If an air link cannot be established, the LCD will show "No
connection" after a 15-second time out.
c. A call duration timer will start displaying the length of the
call after the link is established
d. Before the TALK/Dial/Speaker/Headset button is pressed
or the Handheld is pickup, an incoming call takes priority
and will abort the dialing.
29
Receiving a Telephone Call
1. On a Handset:
a. When an incoming call arrives, the ringer will ring or
vibrate unless the ringer has been turned off
b. If the handset is on the charger cradle (ringer will be
temporarily switched to "Ring" if it has been set to
"Vibrate").
c. If the handset is not on the cradle, press any key (except
END and the SILENT and OPTION soft keys) to answer;
pressing Speaker will start speakerphone operation
d. To switch between Speakerphone and Receiver/Headset:
i)
Press Speaker to switch from Receiver or Headset to
Speakerphone
ii) Press TALK to switch from Speaker to Receiver
iii) Plug in Headset to switch from Receiver or Speaker to
Headset
iv) Unplug Headset will return the voice output to the
Receiver
2. On the Base Unit:
a. When an incoming call arrives, the ringer will ring unless
the ringer has been turned off or the DND button has been
pressed and remain effective
b. The Line Status LED will flash along with the rings on the
line from which the call comes in
c. To answer,
i)
Press the Line Button corresponding to the flashing
Line Status LED to start conversation with
speakerphone, or
ii) Pick up the Handheld, or
iii) Press Speaker to start conversation with
Speakerphone, or
iv) Press Headset to start conversation with headset
d. To switch between Headset, Handheld and Speakerphone,
i)
Press Headset to switch from Speakerphone or
Handheld to Headset, make sure that headset has
been plugged in
ii) Press Speaker to switch from Handheld or Headset to
Speakerphone
iii) Pick up Handheld to switch from speakerphone or
Headset to Handheld
30
Advertisement
Table of Contents
