Error/Warning Indications - Sony VENICE MPC-3610 Operating Instructions Manual

000 68
6. Appendix

Error/Warning Indications

If a warning, caution, or operating condition that requires confirmation occurs on the unit, a message is
displayed on the sub display, the REC lamp starts flashing, and a warning sound is emitted.
The buzzer is output to the built-in speaker or to the headphones connected via the headphone
connector.
When the unit is turned on, a message appears on the sub display screen prompting you to execute APR
if the auto adjustment for the image sensor (APR) has not been performed for a certain period of time. In
this case, follow the on-screen instructions to execute APR (page 49).
Error Display
The unit will stop operation when the following kind of display occurs.
Error display Buzzer REC lamp
indication
E + Error code Intermittent High-speed
flashing
Warning Display
When one of the following messages occurs, use the following table to resolve the problem.
Warning display Buzzer REC lamp
indication
Media Full 1) Continuous High-speed
flashing
Battery End 1) Continuous High-speed
flashing
1)
Temperature High Intermittent Flashing
Cause and Solution
The unit may be defective. Recording stops even if
REC is displayed on the viewfinder screen.
Turn off the power and check the connected
equipment, cables, and media. If the error persists when
the unit is turned on again, contact your Sony service
representative. (If power cannot be turned off by setting
the power switch to OFF, remove the battery pack or
the DC IN source.)
Cause and Solution
Clips could not be recorded, copied, or split because
there is no remaining capacity on the SxS memory card.
Replace immediately.
The battery pack is dead. Recording is disabled.
Stop operation and recharge the battery pack.
The internal temperature is high.
Turn off the unit and allow it to cool down before
operating it again.
Warning display Buzzer REC lamp
indication
Insufficient Voltage 1) Continuous High-speed
flashing
EXT. I/F Signal Error – –
AXS Recorder Temp. – –
1)
High
1)
Message is not displayed on the monitor screen.
Caution and Operation Confirmation Display
The following caution and operation confirmation messages may appear on the monitor screen or sub
display, and warning icons may be displayed and messages displayed in the Info category > Camera
Condition in the menu. Follow the instructions provided to resolve the issue.
Display indication
Battery Error
Please Change Battery
Backup Battery End
Please Change
Cannot Use SxS(A)*
Please Change
Cannot Use SxS(A)*
Unsupported File System
Media Error
SxS(A)* Needs to be Restored
SxS(A)* Error
Recording Halted
Playback Halted
Cause and Solution
The DC IN voltage is too low. Recording is disabled.
Connect another power source.
An error was detected with the signal on the mounting
terminal for an expansion unit.
Check the connection to the AXS-R7 or other device.
The internal temperature of the AXS recorder is high.
Turn off the unit and allow it to cool down before
operating it again.
Cause and Solution
An error was detected in the battery pack.
Replace with a normal battery pack.
The remaining capacity of the backup battery is
insufficient.
Replace the backup battery.
A memory card that has been partitioned or a
memory card containing more clips that can be
handled by the unit was inserted.
The card cannot be used in the unit, and must be
replaced.
A card using a different file system or an unformatted
card was inserted.
The card cannot be used in the unit, and must be
replaced or formatted using the unit.
An error occurred with the memory card. The card
requires restoration.
Restore the card.
Recording or playback stopped because an error
occurred on the memory card.
If the problem persists, replace the memory card.