Philips DVDR1000/001 Service Manual page 81

Diagnostic Software and Faultfinding Trees
Route Audio
Nucleus Number: 713
Description
This nucleus routes the audio on the analogue board to the
destination determined by the input parameters
Path ID
00
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
The paths that are available for audio routing and their
description (Nafta region)
Path ID
00
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
EXAMPLE
DD:> 713 00
71300: Audio routing on the Analogue Board OK.
Test OK @
Description
Input signal is VIDEO(CVBS) from digital board and will be re-routed back to
the digital board.
Input signal is from FRONT AUDIO IN and will be routed to the digital board.
Input signal is from REAR AUDIO IN and will be routed to the digital board.
Input signal is AUDIO from SCART1 and will be routed to the digital board.
Input signal is AUDIO from SCART2 and will be routed to the digital board.
No routing.
No routing.
No routing.
Input signal is VIDEO(CVBS) and AUDIO from ANTENNA IN and will be
routed to SCART1.
Input signal is VIDEO(CVBS) and AUDIO from SCART1 and will be routed to
SCART2.
Input signal is VIDEO(CVBS) and AUDIO from SCART2 and will be routed to
SCART1.
Input signal is AUDIO from dvio board and will be routed to SCART1.
No routing.
No routing.
No routing.
No routing.
No routing.
Input signal is from REAR AUDIO IN and will be routed to SCART1.
Input signal is from FRONT AUDIO IN and will be routed to SCART1.
Description
Input signal is VIDEO(CVBS) from digital board and will be re-routed back to
the digital board.
Input signal is from FRONT AUDIO IN and will be routed to the digital board.
Input signal is from REAR AUDIO IN 1 and will be routed to the digital board.
Input signal is from REAR AUDIO IN 2 and will be routed to the digital board.
No routing.
No routing.
No routing.
No routing.
Input signal is VIDEO(CVBS) and AUDIO from ANTENNA IN and will be
routed to VIDEO(CVBS) OUT and REAR CINCH OUT 2.
No routing.
Input signal is from REAR AUDIO CINCH IN 1 and will be routed to REAR
AUDIO CINCH OUT 2.
Input signal is from FRONT AUDIO CINCH IN and will be routed to REAR
AUDIO CINCH OUT 2.
No routing.
No routing.
No routing.
No routing.
Input signal is AUDIO from dvio board and will be routed to AUDIO CINCH
OUT 2.
DVDR1000 /0x1 /691
The paths that are available for audio routing and their
description (Europe version)
CL 16532095_066.pdf
5. GB 81
140801
CL 16532095_067.pdf
140801