Clean And Disinfect The 4Vetj And Components - Juniper 4VETJ User Manual

the cord to be doubled back near the probe to allow
the probe to be held in place under the cord strap.
!
CAUTION: The crystals in the probes have a limited life.
If the 4VetJ is running but no exam is being done, either
turn the unit off or unhook the probe from the probe
socket. This helps extend the life of the crystals.

Clean and Disinfect the 4VetJ and Components

The 4VetJ and probe should be cleaned and disinfected
before each use and before they are stored, transported, or
sent to our service department for servicing or repairs.
!
CAUTION: It is important to note that the 4VetJ and the
probe connector are not waterproof. Use caution when
cleaning or disinfecting them.
In addition to the information below regarding the cleaning
and disinfecting of the 4VetJ and components, refer to
Appendix A, Clean, Store, Transport, and Recycle.
4VetJ
The 4VetJ must be powered off and unplugged for thorough
cleaning. Use warm water or a mild cleaning solution on the
casing. Remember that the 4VetJ is not waterproof.
Touchscreen
For dry cleaning of the touchscreen, rub it with a soft cloth.
Avoid substances that can scratch or damage the screen.
For damp cleaning use a spray or foam agent designed for
such use, warm water, or a mild detergent.
Probe
Clean and disinfect the probe before each examination.
The probe and cord are waterproof. The probe connector
(which attaches to the probe socket) is not waterproof, so
use caution when you are cleaning or disinfecting the area
near it. Do not scrub the head of the probe. Clean it gently
with a soft cloth and a mild cleaning solution approved for
ultrasound probes. Do not use concentrated, aggressive, or
abrasive agents or substances like alcohol or bleach that
could deteriorate the probe head.
10
4VetJ Ultrasound Scanner User's Manual