Drawer Interface; Drawer Kick Drive Signal; Electronic Characteristics; Connector Description - Toshiba TRST-A10 SERIES Product Description

1. OUTLINE
1.7

DRAWER INTERFACE

1.7.1 Drawer Kick Drive Signal

This signal outputs a pulse specified by ESCp. The SW (+) status can be checked by the
connector pin #34 for the parallel interface, and by DLE, EOT, GSa, GSr commands for the
serial/parallel interface.
1.7.2 Electric Characteristics
1) Drive voltage:
2) Drive current:
3) SW signal: Signal level

1.7.3 Connector Description

No.
1
2
3
4
5
6
Applicable connector: TM5RJ3-66 (HIROSE) or equivalent
Adaptable connector: TM3P-66P (HIROSE) or equivalent
NOTES:
1) The printer cannot output this signal while printing.
2) The drawer 1 and drawer 2 cannot be driven at the same time.
3) A 36ohm-or-more solenoid should be used for the drawer.
4) The output current should not exceed 1.5A, which may cause the printer to be
broken, burned.
5) Connect the solenoid only. A telephone line cannot connect to this drawer
connector.
6) The drawer of which interface is TOSHIBA TEC standard (4-pin modular type
connector) cannot be connected.
DC24V
Max. 1.5A (within 510ms)
"L" = 0 ∼ 0.5V
"H" = 3 ∼ 5V
Signal
FG Case ground
DRAWER1 Drawer1 drive signal
DRSW Drawer switch input
VDR Drawer drive power
DRAWER2 Drawer2 drive signal
GND Common ground on the circuit
Housing Side
Function
Connector Side
1-21
EO10-13009A
(Revision Date: Jan. 18, 2008)
1.7 DRAWER INTERFACE