NEC PH3501QL User Manual page 125

WIRED LAN
INTERFACE
PROFILES
DHCP
IP ADDRESS
SUBNET MASK
GATEWAY
AUTO DNS
DNS CONFIGURA-
TION
RECONNECT
To configure the LAN port, select [LAN].
To configure the HDBaseT port, select[HDBaseT].
• The settings for the wired LAN can be recorded in the projector
memory in two ways.
• Select [PROFILE 1] or [PROFILE 2] and then do settings for
[DHCP] and the other options.
After doing this, select [OK] and press the ENTER button. This
will store your settings in memory.
• To recall the settings from memory:
After selecting [PROFILE 1] or [PROFILE 2] from the [PRO-
FILES] list.
Select [OK] and press the ENTER button.
Place a check mark to automatically assign an IP address to the
projector from your DHCP server.
Clear this check box to register the IP address or subnet mask
number obtained from your network administrator.
Set your IP address of the network connected to the projector
when [DHCP] is turned off.
NOTE:
• System IP addresses such as 192.168.254.XXX cannot be set.
Set your subnet mask number of the network connected to the
projector when [DHCP] is turned off.
Set the default gateway of the network connected to the projector
when [DHCP] is turned off.
Place a check mark to automatically assign the IP address of your
DNS server connected to the projector from your DHCP server.
Clear this check box to set the IP address of your DNS server
connected to the projector.
Set the IP address of your DNS server on the network connected
to the projector when [AUTO DNS] is cleared.
Retry to connect the projector to a network. Try this if you have
changed [PROFILES].
108
5. Using On-Screen Menu
—
—
—
Up to 12 numeric
characters
Up to 12 numeric
characters
Up to 12 numeric
characters
Up to 12 numeric
characters
Up to 12 numeric
characters
—