Table of Contents
Advertisement
15 TUNING THE ENGINE
15.7
15.8
15.9
15.10
102
Plug-in connector of ignition timing map adjustment
K00975-10
Changing the ignition timing map
K00975-10
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the driver's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
400692-10
Adjusting the basic position of the shift lever
401950-12
1
Plug-in connector
of the ignition timing map adjustment is
located on the frame under the fuel tank.
Possible states
Soft – The plug-in connector of the ignition timing map
•
adjustment is disconnected to achieve better rideability.
Performance – The plug-in connector of the ignition timing
•
map adjustment is joined to achieve higher performance.
Switching the ignition timing map from Performance to Soft
–
Disconnect plug-in connector
map adjustment.
Soft – Better rideability
Switching the ignition timing map from Soft to Performance
–
Join plug-in connector
adjustment.
Performance – Higher performance
–
Sit on the vehicle in the riding position and determine
A
distance
between the upper edge of your boot and the
shift lever.
Distance between shift lever
and upper edge of boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
(
p. 102)
–
1
Remove screw
with the washers and take off shift
2
lever
.
1
of the ignition timing
1
of the ignition timing map
10 ... 20 mm (0.39 ...
0.79 in)
Advertisement
Table of Contents
