Plug-In Connector Of Ignition Timing Map Adjustment; Changing The Ignition Timing Map; Checking The Basic Position Of The Shift Lever - Husqvarna TC 125 2019 Owner's Manual

15.7

Plug-in connector of ignition timing map adjustment

15.8

Changing the ignition timing map

Switching the ignition timing map from Performance to Soft
–
Disconnect plug-in connector
Soft – better rideability
Switching the ignition timing map from Soft to Performance
–
Join plug-in connector
Performance – better performance
15.9

Checking the basic position of the shift lever

Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
Main work
–
Place a cloth under the carburetor to capture the draining
fuel.
–
Remove screw plug
–
Fully drain the fuel.
–
Mount and tighten the screw plug.
S01290-10
Plug-in connector
located on the frame under the fuel tank.
Possible states
Soft – The plug-in connector of the ignition timing map
•
adjustment is disconnected to achieve better rideability.
Performance – The plug-in connector of the ignition timing
•
map adjustment is joined to achieve higher performance.
K00912-10
1
of the ignition timing map adjustment. (Figure K00912-10
1
of the ignition timing map adjustment. (Figure K00912-10
–
Sit on the vehicle in the riding position and determine
distance
shift lever.
Distance between shift lever
and upper edge of boot
» If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
(
400692-10
TUNING THE ENGINE 15
1
.
1
of the ignition timing map adjustment is
A
between the upper edge of your boot and the
10 ... 20 mm (0.39 ...
0.79 in)
p. 108)
p. 107)
p. 107)
107