What To Do If - Electrolux EVYP9841AX Manual

13.1 What to do if...

Problem
You cannot activate or op-
erate the oven.
The oven does not heat up. The oven is deactivated.
The oven does not heat up. The clock is not set.
The oven does not heat up. The necessary settings are
The oven does not heat up. The automatic switch-off is
The oven does not heat up. The Child Lock is on.
The oven does not heat up. The door is not closed cor-
The oven does not heat up. The fuse is blown.
The lamp does not operate. The lamp is defective.
The display shows F111.
The display shows an error
code that is not in this ta-
ble.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
Possible cause
The oven is not connected
to an electrical supply or it
is connected incorrectly.
not set.
activated.
rectly.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the
socket.
There is an electrical fault.
You left the dish in the oven
for too long.
The demo mode is activa-
ted.
ENGLISH
Remedy
Check if the oven is correct-
ly connected to the electri-
cal supply (refer to the con-
nection diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Fully close the door.
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Put the plug of the core
temperature sensor as far
as possible into the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, con-
tact the Customer Care
Department.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
Refer to "Basic Settings" in
"Daily use" chapter.
41