Table of Contents
Advertisement
12. CARE AND CLEANING
WARNING!
Refer to Safety chapters.
12.1 Notes on cleaning
Clean the front of the oven with a soft
cloth with warm water and a mild cleaning
agent.
To clean metal surfaces, use a dedicated
cleaning agent.
Clean the oven interior after each use. Fat
accumulation or other food remains may
result in a fire. The risk is higher for the grill
pan.
Clean all accessories after each use and
let them dry. Use a soft cloth with warm
water and a cleaning agent.
Clean stubborn dirt with a special oven
cleaner.
If you have nonstick accessories, do not
clean them using aggressive agents,
sharp-edged objects or a dishwasher. It
can cause damage to the nonstick
coating.
Dry the oven when the cavity is wet after
usage.
12.2 Removing the shelf
supports
Before maintenance, make sure that the
oven is cool. There is a risk of burns.
To clean the oven, remove the shelf
supports.
1. Pull carefully the supports up and out
of the front catch.
2. Pull the front end of the shelf support
away from the side wall.
3. Pull the supports out of the rear catch.
Install the shelf supports in the opposite
sequence.
12.3 Steam Cleaning
Remove the worst dirt manually.
1. Put 250 ml of water with 3
tablespoons of vinegar directly into the
steam generator.
2. Turn on the function: Steam Cleaning.
The display shows the duration of the
function. An acoustic signal sounds when
the programme is completed.
3. Touch any symbol to turn off the
signal.
4. Wipe out the appliance with a soft
cloth. Remove the water from the
steam generator.
Let the appliance dry fully with the door
open for approximately 1 hour.
To speed up the drying you can close the
door and heat up the appliance with the
function: True Fan Cooking at temperature
150°C for approximately 15 minutes.
12.4 Decalcification of the
Steam generator
1. Put 250 ml of water mixed with 3
tablespoons of vinegar directly into the
steam generator.
2. In the menu choose: Assisted
Cleaning.
3. Activate the function: Decalcification.
The display shows the duration of the
function (15 minutes).
An acoustic signal sounds when the
programme is completed.
4. Touch a sensor field to deactivate the
signal.
5. Remove the remaining water from the
steam generator.
6. Keep the door open for approximately
1 hour to let the appliance dry fully. To
speed up the drying you can heat up
the appliance with hot air at
temperature 150 °C for approximately
15 minutes.
12.5 Removing and installing the
door
You can remove the door to clean it.
ENGLISH
39
Advertisement
Table of Contents
