Inserting The Accessories - Electrolux EVYP9841AX Manual

The core temperature sensor measures
the core temperature of the meat. When
the meat is at the set temperature, the
oven turns off.
CAUTION!
Only use the core
temperature sensor supplied
or the correct replacement
parts.
The core temperature sensor
must stay in the meat and in
the socket during the
cooking.
1. Turn on the oven.
2. Put the tip of the core temperature
sensor into the centre of the meat.
3. Put the plug of the core temperature
sensor into the socket at the front of
the oven.
The display shows the core temperature
sensor symbol.
4. Press or
seconds to set the core temperature.
5. Set the heating function and, if
necessary, the oven temperature.
The oven calculates an approximate end
time. The end time is different for the
different quantities of the food, the set
oven temperatures (minimum 120 °C) and
the operating modes. The oven calculates
the end time in approximately 30 minutes.
6. To change the core temperature,
press .
When the meat is at the set core
temperature, a signal sounds. The oven
turns off automatically.
7. Press any symbol to stop the signal.
in less than 5
8. Remove the core temperature sensor
plug from the socket and remove the
meat from the oven.
9. Press
to turn off the oven.
WARNING!
The core temperature sensor
is hot. There is a risk of
burns. Be careful when you
remove the tip and the plug
of the core temperature
sensor.

9.2 Inserting the accessories

CAUTION!
Do not use the baking tray or
deep pan with the Full Steam
function.
Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
Baking tray/ Deep pan:
Push the baking tray / deep pan between
the guide bars of the shelf support.
Wire shelf and baking tray / deep pan
together:
ENGLISH 17