Q-See QSD32824-250 User Manual page 16

C: [MOTION DETECTION]
[CHANNEL]
Values are "1, 2, 3, 4, Off". The maximum sensitivity level is 4.
[MOTION AREA]
Use this option to select the size of the area that you want to be sensitive to motion.
Use the keypad button, remote control button or mouse to assign the area.
The keypad and mouse control instructions are below.
[Using keypad or remote control button]
Press [SEL] once to pick the area, press [SEL] twice to cancel the area.
CH1 - Up / CH2 - Down / CH3 - Left / CH4 - Right
[Using Mouse button]
While holding a left mouse button, move the mouse to select, deselect or reselect the motion
detection area for recording.
The area only can be selected from up to down and from left to right. When the block is
covered by blue shadow, it's active to record. When the block is transparent, it will not be
recorded.
After completing the motion area setting, press "MENU" button or use the right mouse click
button to exit.
Before starting Motion Recording, user must complete the "Motion area" setup.
Operation Manual-4CH Duplex DVR
Select the channel or channels (1,2,3,4) that
you want to record when motion is detected.
[SENSITIVITY]
You can adjust the sensitivity of the built-in
motion sensor on the DVR system. The higher
the number, the higher the sensitivity is.
14