9 - Use a utility knife to cut out the cabinet insulation for
the right side vent / air intake.
10 -Install the two 90° street elbows (provided) through the
side of the cabinet. The male side of each elbow
should extend down through the blower deck and con
nect to the rubber fittings below. Once the elbows are
properly positioned, tighten each clamp.
11 -Peel protective backing from side vent sealing gaskets
(2) and apply to side vent sealing plates (2) as shown
in figure 19.
12 -Install the side vent sealing plates and gaskets on the
exterior of the cabinet as shown in figure 19. Secure
with six mounting screws (four reused and two pro
vided from bag assembly). Holes are pre-punched in
the parts and cabinet, no drilling is required.
13 -Install sheet metal screws (provided) to seal extra two
holes in cabinet not used with side vent clamps.
IMPORTANT
Side vent sealing plates and side vent sealing gas
kets must be used when converting to right side
venting. Failure to use gaskets and plates may lead
to improper operation of unit.
Top Vent Configuration
FIGURE 17
Exhaust/Air
Intake Connections
Pipe Clamp
Hose Clamp
Page 32
Patch Plate Top Cap
Sheet Metal
Patch Plate
FIGURE 18