Installation Workflow - Bosch B450 Installation And Operation Manual

6 en | Introduction
2.3

Installation workflow

To install and configure the module, use the workflow below.
Caution!
Remove all power (AC and battery) before making any connections. Failure to do so might
!
result in personal injury and/or equipment damage.
compatible control panel. Refer to Bus address settings, page 9.
(required), page 12.
control panel, page 15.
instructions for cellular communicator.
2017.10 | 09 | F.01U.300.740
Plan the installation of the B450 Conettix Plug-in Communicator Interface.
Unpack the device contents.
Power down the system.
Set the bus address value to automatically configure the module to work with a
Insert a plug-in communicator into the module. Refer to Inserting a plug-in cellular module
Mount the module into the enclosure. Refer to Mounting the module, page 13.
Wire the module to a compatible control panel. Refer to Connecting the module to the
Power up the system.
Install a communication program (if required). Refer to Get started, page 22.
Configure the communication module (SDI and option bus control panels).
Verify LED activity. Refer to LED status indicators, page 41.
Review the signal strength of the cellular communicator. Refer to the installation
Installation and Operation Guide
Conettix Plug-in Communicator Interfaces
Bosch Security Systems, Inc.