Configuration; Configuration Parameters - Bosch B450 Installation And Operation Manual

Conettix Plug-in Communicator Interfaces
5

Configuration

Configure the module using one of the methods described in this section. Not all options work
for all control panel types.
–
–
–
Before you begin, review the B450 configuration information in the next section.
5.1

Configuration parameters

This section gives details about each of the parameters for the B450. Use this information to
program a control panel for PnP, for USB configuration, or for SMS configuration. In this
section, the parameters are listed in the order you see them in the USB menus. Not all
parameters are available in all configuration programs.
(USB menu [3] Basic Configuration)
TCP/UDP Port Number
Default: 7700
Selections: 0 - 65535
For IP communications with RPS, automation, or Remote Security Control (RSC) in typical
installations, keep the TCP/UDP Port at the default
AES Encryption
Default: No Encryption
Selections:
–
–
–
–
Select the AES key size.
Module Enclosure Tamper
Default: No - Disable
Selections:
Yes - Enable enclosure tamper input
No - Disable enclosure tamper input
This parameter enables the enclosure tamper switch input on the SDI2 module.
When the input is enabled and connected to a Bosch ICP-EZTS tamper switch installed in the
module enclosure, the control panel can create a tamper event when the enclosure door is
opened, or when the enclosure is removed from the wall.
Panel Programming Enable
Default: Yes
Selections: Yes, No
Yes - Control panel programming is enabled.
No - Control panel programming is disabled.
Bosch Security Systems, Inc.
Plug and Play (PnP) configuration, page 21 (SDI2 and some option bus control panels)
USB configuration, page 22 (all control panels)
SMS configuration, page 34 (all control panels)
No Encryption
128 bits - 16 bytes
192-bit - 24 bytes
256-bit - 32 bytes
Installation and Operation Guide
Configuration | en 17
2017.10 | 09 | F.01U.300.740