Status Menu - Bosch B450 Installation And Operation Manual

Conettix Plug-in Communicator Interfaces
Notice!
Unsaved changes are lost if you do not press a key within 5 minutes. Tera Term automatically
logs out of the module.
Main Menu options overview
Option
1. Status (Starts
with Basic
Status)
2. Change
Passcode
3. Basic
Configuration
4. Advanced
Configuration
5. Reset to
Factory Defaults
6. Diagnostic
Log
7. Firmware
Update
8. Exit
5.3.4

Status menu

Basic Status menu overview
The following section describes the Status menu parameters.
Bosch Security Systems, Inc.
Description
Shows the link, modem, and bus status
Use to change the login passcode, enter the new passcode twice. The
second entry confirms the new passcode.
Passcodes must be 4 to 10 characters long, and are case-sensitive.
0-9, A-Z, a-z, and special characters are allowed.
Notice!
If SMS configuration is used, do not use semicolon (;) or exclamation
mark (!) as part of the passcode.
Use to program Basic Configuration options. Press 0 to return to the Main
menu.
To change a basic parameter, select the option to change, and then enter
in the new value.
Use to program advanced options. Press 0 to return to the Main Menu.
To change an advanced parameter, select the option to change, and then
enter in the new value.
Use to reset all factory default values. All fields are cleared and the factory
default values are restored.
Notice!
A non-defaulted SDI2 control panel overwrites the default settings if
connected to the defaulted module.
The Diagnostic Log option is used to troubleshoot communication
problems. Only use of the Diagnostic Log option at the direction of Bosch
Technical Support. For more information, refer to Diagnostic log, page 44.
Use to update the B450 firmware. For more information refer to Firmware
updates, page 38.
Select to exit the menu and log out. You must enter the passcode to log
back in.
Notice!
If you make configuration changes but do not save the changes, Tera Term
prompts you.
Installation and Operation Guide
Configuration | en 29
2017.10 | 09 | F.01U.300.740