Using The Control Panel; Auto-Restart - EdgeStar AP12000HS Owner's Manual

Button
Power
Mode
Speed

Timer

(Up)

(Down)
Indicator
Water Light
Timer Light
LCD Display
Infrared Sensor

Using the Control Panel

Power:
Use the Power button to turn the portable air conditioner on and off.
By default when you first use the power button, the unit will begin to operate in cooling mode.
The unit will remember the last used mode / settings if you shut it down and restart it.
Auto-Restart: If power to the unit is interrupted, the air conditioner will restart itself in its last
used mode / settings once power is restored. The compressor will restart after three (3)
minutes.
Cooling Mode:
Cooling mode cools and dehumidifies the air. If the ambient temperature drops below the
temperature you selected, the compressor turns off and the unit functions with the fan only.
When the temperature rises above the temperature you selected, the compressor turns on
again.
To operate the unit in cooling mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button.
3. Press the Mode button until the LED indicator next to "Cooling" lights up.
4. Select the fan speed by using the Speed button.
5. Set the thermostat by using the Up and Down buttons. The thermostat is adjustable
between 61°F - 89°F in one degree increments.
Note: The exhaust hose must be used in Cooling mode in order to cool a room.
9
Function
This button powers the unit on or off.
This button changes between cool, dehumidify, heat, and fan
modes. The indicator light will turn on next to the mode you set.
Heating mode will display a red indicator light.
This button sets the fan speed. The High, Medium, or Low
indicator light will turn on next to the fan speed you set.
This button enables the timer.
This button increases the set temperature or the time when the
Timer button is enabled.
This button decreases the set temperature or the time when the
Timer button is enabled.
Function
The water light will turn on if the internal water reservoir is full.
The timer light indicates that you have set the timer. Use the Up
and Down buttons to set the number of hours desired for the timer.
The LCD can display the ambient temperature, set temperature,
and the number of hours when setting the timer.
This screen is the receiver for the remote control.