Servicing The Engine Oil - Toro TimeCutter SW 4200 Operator's Manual

Installing the Air Cleaner
1. Install the foam element over the paper element.
Note:
Ensure that you do not damage the
elements.
2. Align the holes of the filter into the manifold
ports.
3. Rotate the filter down into the chamber and fully
seat it against the manifold
Figure 32
4. Close the cover.
(Figure 32).
g228022
33

Servicing the Engine Oil

Engine-Oil Specifications
Oil Type: Detergent oil (API service SF, SG, SH, SJ,
or SL)
Crankcase Capacity: 2.4 L (81 fl oz) with oil filter
Viscosity: See the table below.
Figure 33
Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note:
Check the oil when the engine is cold.
Important:
If you overfill or underfill the engine
crankcase with oil and run the engine, you may
damage the engine.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Note:
Ensure that the engine is cool so that the
oil has had time to drain into the sump.
3. To keep dirt, grass clippings, etc., out of the
engine, clean the area around the oil-fill cap and
dipstick before removing it
g029683
(Figure 34).