Lubrication; Greasing The Bearings; Engine Maintenance; Engine Safety - Toro TimeCutter SW 4200 Operator's Manual

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all the
lubrication points.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake; refer to Shutting Off the Engine (page
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
29) with a rag.
Note:
Scrape any paint off the front of the
fitting(s).
Figure 28
1. Front caster tire
Figure 29
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4. Connect a grease gun to each fitting
and Figure 29).
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
22).
(Figure 28 and Figure
g027752
decal106-8717
3. Grease every 25 operating
hours
4. Engine
(Figure 28

Engine Maintenance

Engine Safety

•
Shut off the engine before checking the oil or
adding oil to the crankcase.
•
Keep your hands, feet, face, clothing, and other
body parts away the muffler and other hot surfaces.

Servicing the Air Cleaner

Service Interval: Before each use or daily
Note:
Service the air cleaner more frequently (every
few hours) if operating conditions are extremely dusty
or sandy.
Removing the Foam and Paper
Elements
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean around the air-cleaner cover to prevent
dirt from getting into the engine and causing
damage.
4. Lift the cover and rotate the air-cleaner assembly
out of the engine
31
(Figure 30).