Product Overview; Controls - Toro TimeCutter SW 4200 Operator's Manual

Product Overview

1. Traction-control pedal
2. Height-of-cut lever
3. Smart Park ™ switch
4. Steering wheel
5. Control panel
6. Operator seat

Controls

Become familiar with all the controls before you start
the engine and operate the machine.
Control Panel
1. Smart Park™ switch
2. Throttle control
3. Choke control
4. Key switch
Figure 5
7. Engine
8. Fuel-tank cap
9. Rear drive wheel
10. Key Choice ® control
11. Mower deck
12. Front caster wheels
Figure 6
5. Blade-control switch
(power takeoff)
6. Parking brake—On
7. Parking brake indicator
light
8. Parking brake—Off
1. Operating–in–Reverse
warning light
2. Key Choice key (blue in
color)
Key Switch
g027935 The key switch, used to start and shut off the engine,
has 3 positions: O
Starting the Engine (page
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position (Figure
Choke Control
Use the choke control to start a cold engine.
Blade-Control Switch (Power
Takeoff)
The blade-control switch, represented by a
power-takeoff (PTO) symbol, engages and
disengages power to the mower blades
Fuel-Presence Window
You can use the fuel window, located on the left side
of the machine, to verify the presence of fuel in the
tank (Figure 7).
g028250
Height-of-Cut Lever
Use the height-of-cut lever to lower and raise the deck
from the seated position. Moving the lever up (toward
you) raises the deck from the ground and moving the
lever down (away from you) lowers the deck toward
the ground. Adjust the height-of-cut only while the
machine is not moving
13
Figure 7
3. Fuel-presence window
, R , and S
FF UN TART
22).
LOW
6).
(Figure 20).
g028251
. Refer to
to F
AST
(Figure 6).