Positioning The Seat - Toro TimeCutter SW 4200 Operator's Manual

10. Return to the seat and engage the blades by
pulling up the blade-control switch.
11. Rise from the seat. The blades should
disengage and the engine should continue to
run.
12. Return to the seat and pull up the blade-control
switch. The blades should engage. Disengage
the blades by pushing down the blade-control
switch.
13. Pull up the blade-control switch to engage the
blades. Move the traction pedal to the
position. The blades should disengage. Move
the traction pedal to the
14. Pull up the blade-control switch to engage the
blades. Turn the Key Choice switch to the
position and release it. The operating-in-reverse
light should illuminate.
15. Move the traction pedal to the
The blades should remain engaged. Push the
blade-control switch in to disengage the blades.
The operating-in-reverse light should turn off.
Move the traction pedal to the
16. If not engaged, push the SmarkPark switch to
the position and lightly tap the traction pedal
ON
to either the
FORWARD
brake should disengage and the brake light
should turn off.
Note:
Tap the pedal, do not fully engage the
pedal as that causes the brake system to bind
and not release.
17. With the brake released, engage the traction
pedal slightly and rise from the seat. The engine
should shut off.
18. Return to the seat and turn the key to the
position. After several seconds, the brake
system should engage.
Note:
With the key in the
brake light does not illuminate.
REVERSE
position.
NEUTRAL
ON
position.
REVERSE
position.
NEUTRAL
or position. The
REVERSE
OFF
position, the
OFF

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable
17
(Figure 9).
Figure 9
g188217