Yamaha Kodiak 450 Owner's Manual page 37

EBU18081
Engine stop switch "
Set this switch to " " before starting the engine.
The engine stop switch controls the ignition and
stops the engine when it is running. Use this
switch to stop the engine in an emergency situa-
tion. The engine will not start or run when this
switch is set to " ".
EBU18102
Start switch " "
Push this switch to crank the engine with the start-
er. See the starting instructions on page 6-1 prior
to starting the engine.
EBU34123
Light switch " /
Set this switch to " " to turn on the left and right
headlights (low beams) and the taillight. Set the
switch to " " to turn on the left and right head-
lights (high beams), the handlebar-mounted light
(YFM45KPXJ / YFM45KPAJ / YFM45KPHJ), and
the taillight. Set the switch to "OFF" to turn off all
the lights.
/ "
/OFF"
ECB00046
NOTICE
Do not use the headlights with the engine
turned off for an extended period of time. The
battery may discharge to the point that the
starter will not have enough power to crank the
engine. If this should happen, remove the bat-
tery and recharge it. (See page 8-51.)
EBU18171
Horn switch "
Press the switch to sound the horn.
EBU28433
On-Command four-wheel-drive switch
"2WD"/"4WD"
EWB00164
WARNING
Always stop the ATV before changing from
two-wheel drive to four-wheel drive and vice
versa. The ATV handles differently in two-
wheel drive than in four-wheel drive in some
circumstances. Changing from two-wheel
drive to four-wheel drive or vice versa while
moving may cause the ATV to unexpectedly
4-7
"
4