Yamaha Kodiak 450 Owner's Manual page 33

ECB02400
NOTICE
 The engine may overheat if the ATV is over-
loaded. In this case, reduce the load to spec-
ification.
 The engine may also overheat if mud or dirt
has accumulated on the radiator (i.e., after
riding in wet terrain). In this case, have a
Yamaha dealer clean the radiator.
 Start the engine after making sure that the
warning light is out. Continuous use while
the warning light is on may cause damage to
the engine.
EBU29943
Engine trouble warning light "
This warning light comes on or flashes when an
electrical circuit monitoring the engine is not work-
ing correctly. When this occurs, have a Yamaha
dealer check the self-diagnosis system.
The electrical circuit of the warning light can be
checked by turning the key to "
warning light should come on for a few seconds,
and then go off.
If the warning light does not come on initially when
the key is turned to "
light remains on, have a Yamaha dealer check the
electrical circuit.
EBU30571
Electric Power Steering warning light "EPS"
(for EPS model)
This warning light comes on when the key is
turned to "
engine is started. If the warning light remains on or
comes on after the engine is started, the EPS sys-
tem may not be working correctly. When this oc-
curs, have a Yamaha dealer check the EPS
system.
The electrical circuit of the warning light can be
"
checked by turning the key to "
warning light does not come on, have a Yamaha
dealer check the electrical circuit.
TIP
 If the engine is stopped using the engine stop
" (on). The
4-3
" (on), and then goes off once the
switch and the key is in the "
the EPS warning light comes on to indicate that
the power assistance for the steering is not
functioning.
" (on), or if the warning
" (on). If the
" (on) position,
4